Scantech Vega V-1010 Instrukcja Użytkownika Pobierz pdf (Strona 23)

Scantech-ID VEGA Linear Imager 19

2. When control the Bluetooth device to search the scanner, enter pin

code (default 00:00:00:00) to setup comport.

3. When VEGA scanner is successful connected, scanner will initiate with

short beep sounds. Blue and red led will also blink followed by a long

beep sound. Blue led will slow flash to finish the set up.

4.3.4 Sleep Mode

The VEGA scanner is equipped with sleep mode function to save battery

energy, when the VEGA scanner is not used for 1 minute or 10 minute time

(option 10 minute). During sleep mode all the functions and connection will

be halted, after press the red trigger button the scanner can be wake up and

reconnect the communication with the cradle or Bluetooth device. By

scanning the according programming code, see chapter 7.

4.3.5 Memory Mode

This memory mode function is enabled when you have scanned

“memory on” barcode. Scanning data is stored in the memory of the

VEGA scanner. This function is disabled when you have scanned

“memory off” barcode.

When scan barcode “memory read” barcode stored data will be

immediately transmit to the cradle after reconnection. when scan

barcode “memory clear” barcode all stored memory data will be erased.

The capacity of this memory depends on the scanned data size,

approximately 50 sets of data.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 120 121

Brak uwag

Scantech Vega V-1010 Instrukcja Użytkownika Strona 23