Scantech Vega V-1010 Instrukcja Użytkownika Pobierz pdf (Strona 30)

26 Configuring the VEGA

6.1 PREFACE

How to configure the VEGA:

The Barcode programming feature gives the possibility to change the VEGA

scanner settings with use programming labels.

6.1.1 Changing Scanner Settings with Programming

Codes

You can set-up your VEGA by scan all necessary programming codes for

parameters that meet applications.

In order to change the scanner settings please follow the sequence below:

1. Power-up the scanner.

2. Open the scanner programming mode by scanning

Start Configuration.

3. Change scanner settings by scanning any of the programming code

that meet applications.

4. Close the scanner programming mode by scanning

End Configuration.

5. Save configuration by scanning

Save Parameters

An Example:

For changing the Baud rate to 38400 the following codes must be scanned

successively:

Start configurationBaud rate 38400End configuration Save Parameters

After reading a valid programming code the scanner will give a double High

beep and the green led indicator will lights on.

By scanning “Set All Default” label, the settings will go back to the factory

default settings.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 120 121

Brak uwag

Scantech Vega V-1010 Instrukcja Użytkownika Strona 30